After Power Failure, My Hp Psc 2400 Photosmart Series All-in-one Will Not Respond In Anyway Only Blinks. Help!
Filed in Deskjet Help Forums on ต.ค..25, 2009
I have tried resetting the factory defaults. I have unplugged and replugged. There has to be something that will reset my photosmart printer? Thanks for your help.
ตุลาคม 25th, 2009 at 5:06 pm
If you did not have it plugged into a surge protector then something might have been burned out. Also you can try and unplug it for 15 Min’s or so and try it again. I know this is a dumb question but you did make sure there was paper in it?if all else fails you will have to take it to a professional or replace it .good luck to you
ตุลาคม 25th, 2009 at 8:06 pm
Andy Griffith would always open his radio up and spit
in the back, and whomp it. Hope this helps.
ตุลาคม 25th, 2009 at 11:22 pm
The bad news it’s fired ..the ggood news your computer aperently isn’t, printers are cheaper to purchase.